Den genauen Herstellungszeitraum, für die Vorkriegshalbbügel Versionen zu bestimmen, ist wegen der fehlenden Werksunterlagen aus dieser Zeit, sehr schwierig. Ich gehe daher nach den technischen Änderungen. Hier die Version III von 1940, aber nur geschätzt.
Determining the exact production period for the pre-war half-bail versions is very difficult due to the lack of factory records from that time. Therefore, I am basing my decision on the technical changes. Here is version III from 1940, but this is only an estimate.

Halbbügel, 3. Ausführung, mit Sicherungsstiften
Ohne Serien Nr.
Artikel Nr. 039
Kleine Pertinax Spule
Nierenförmiger Achsantrieb
Antrieb verschraubt
Rotor mit Bohrung
2 geschraubte Bügelauslöser
Half-Bail, 3st Version, with pins
Without serial number
Item No. 039
Small Pertinax spool
Kidney-shaped axle drive
Drive bolted on
Rotor with bore
2 riveted ironing triggers

Auch hier sieht man, diese Rolle hat schon einiges erlebt.
Here, too, you can see that this reel has certainly seen a lot.

Ein Rollenfuß aus Stahl wurde mit 2 Schrauben montiert, wahrscheinlich war der originale Fuß abgebrochen?
A steel reel foot was installed using two screws, the original foot had likely broken off.

Hier die neue Form vom Mitnehmer, er ist jetzt Nierenförmig gebogen und etwas breiter.
Here is the new shape of the drive, it is now kidney-shaped and slightly wider.

Mit der Bohrung für die Wartung.
With the bore for maintenance.

Mit geschraubten Schaltstiften.
With screw-in switch pins.

Hier sieht man, der „neue“ Rollenfuß wurde Flachstahl gebogen, gebohrt und Autogen geschweißt. Ein sehr großer Aufwand, aber anscheinend hat es sich gelohnt?
As you can see here, the „new“ reel foot was bent from flat steel, drilled, and oxy-acetylene welded. A tremendous amount of effort, but apparently, it was worth it?

Es wurden 2 Senkschrauben, mit Sechskantmuttern und Federringen verwendet.
Two countersunk screws, with hexagonal nuts and spring washers, were used.